LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Front Wheel Drive/Drum) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the brake drum. Refer to Brake Drum Replacement in Drum Brakes.
    4. Fig 1: Identifying Wheel Bearing/Hub Bolts - Rear
    GM813284Courtesy of GENERAL MOTORS CORP.
  4. Remove and discard the wheel bearing/hub bolts.
  5. Remove the wheel bearing/hub.
    6. Fig 2: View Of Hub & Bearing Assembly - Rear
    GM230412Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the wheel speed sensor electrical connector (2).
scientia non olet · About LEMON Manuals