LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Disc and AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub Assembly And The Knuckle
    GM809973Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub assembly (1) on to the knuckle (2).
    2. Fig 2: Locating Wheel Bearing/Hub Assembly Knuckle Bolts
    GM809968Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts (1) into the wheel bearing/hub assembly.

    Tighten:  Tighten the wheel bearing/hub bolts to 130 N.m (96 lb ft).

  3. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals