LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Shock Absorber Upper Bolt & Lower Nut (All Wheel Drive)
    GM629248Courtesy of GENERAL MOTORS CORP.
  1. Install the shock absorber.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the shock absorber upper bolt (1).

    Tighten:  Tighten the shock absorber bolt (2 and 3) to 85 N.m (63 lb ft).

  3. Install the shock absorber lower nut.

    Tighten:  Tighten the shock absorber nut to 85 N.m (63 lb ft).

  4. If the vehicle is equipped with automatic level control, install the air tube connector to the shock absorber.
  5. Remove the utility stand.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals