LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Rear Suspension System) >> Repair Instructions >> Knuckle Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel speed sensor connector bracket to the knuckle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wheel speed sensor connector bracket bolt and nut.

    Tighten:  Tighten the wheel speed sensor bracket nut to 12 N.m (106 lb in).

    3. Fig 1: View Of Ball Joint, Knuckle & Nut
    GM629211Courtesy of GENERAL MOTORS CORP.
  3. Install the knuckle into the vehicle.
  4. Install the ball joint to the knuckle nut.

    Tighten:  Tighten the ball joint nut to 60 N.m (44 lb ft).

    5. Fig 2: View Of Upper Control Arm And Knuckle
    GM629210Courtesy of GENERAL MOTORS CORP.
  5. Connect the upper control arm to the knuckle.

    Tighten:  Tighten the upper control arm nut to 85 N.m (63 lb ft).

  6. If necessary, connect the height sensor link to the lower control arm.
  7. Connect the tie rod to the knuckle.

    Tighten:  Tighten the tie rod nut to 80 N.m (59 lb ft).

    8. Fig 3: View Of Jack Under Control Arm
    GM629521Courtesy of GENERAL MOTORS CORP.
  8. Remove the utility stand supporting the lower control arm.
  9. Install the wheel bearing/hub. Refer to Wheel Bearing/Hub Replacement - Rear (Front Wheel Drive/Drum)  or Wheel Bearing/Hub Replacement - Rear (Disc and AWD) .
  10. Install the rear wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals