LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Rear Suspension System) >> Repair Instructions >> Coil Spring Replacement (Front Wheel Drive with Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coil Springs & Components (Front Wheel Drive with Axle)
    GM185822Courtesy of GENERAL MOTORS CORP.
    NOTE: Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.
    IMPORTANT: Position the spring so that the paint stripe (6) is facing rearward and centered to the shock absorber.
  1. Install the springs (4) and the insulators (5) to the rear axle.
  2. Use the utility stand in order to raise the rear axle.
  3. Install the rear axle tie rod to the rear axle. Refer to Tie Rod Replacement (Front Wheel Drive)  or Tie Rod Replacement (All Wheel Drive) .
  4. Install the shock absorbers to the rear axle. Refer to Shock Absorber Replacement (Front Wheel Drive)  or Shock Absorber Replacement (All Wheel Drive) .
  5. Remove the utility stand.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals