LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Rear Suspension System) >> Repair Instructions >> Coil Spring Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coil spring.
    2. Fig 1: View Of Coil Spring
    GM629214Courtesy of GENERAL MOTORS CORP.
  2. Install the spring jounce bumper to the spring.
  3. Index and install the spring insulator to the spring (2).
  4. Index and install the spring assembly to the control arms (1).
    5. Fig 2: View Of Jack Under Control Arm
    GM629521Courtesy of GENERAL MOTORS CORP.
  5. Use the utility stand in order to raise the lower control arm.
    6. Fig 3: View Of Ball Joint, Knuckle & Nut
    GM629211Courtesy of GENERAL MOTORS CORP.
  6. Install the lower ball joint to the knuckle.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the lower ball joint nut.

    Tighten:  Tighten the lower ball joint nut to 60 N.m (44 lb ft).

  8. Install the stabilizer shaft link to the lower control arm. Refer to Stabilizer Shaft Link Replacement (All Wheel Drive) .
    9. Fig 4: Identifying Speed Sensor Harness Connector
    GM629523Courtesy of GENERAL MOTORS CORP.
  9. Install the speed sensor connector mounting bracket.
  10. Connect the speed sensor harness to the control arm.
  11. Connect the speed sensor harnesses.
  12. Connect the shock absorber to the lower control arm. Refer to Shock Absorber Replacement (Front Wheel Drive)  or Shock Absorber Replacement (All Wheel Drive) .
  13. Connect the height sensor link to the lower control arm as necessary.
  14. Install the brake caliper. Refer to Brake Caliper Replacement - Rear in Disc Brakes.
  15. Install the rear wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  16. Inspect and adjust the rear camber and toe angles as necessary. Refer to Rear Camber Adjustment (AWD) in Wheel Alignment.
  17. Lower the vehicle.
scientia non olet · About LEMON Manuals