LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Automatic Transmission Servicing) >> Removal & Installation >> Shift Cable (Console Shift) >> Installation

Shift Cable (Console Shift): Installation

WARNING: This page is about a different car, the 2002 Cadillac Seville, 2002 Cadillac Eldorado, and 2002 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift cable through the cowl panel and seat the grommet. See Figure . Slide the shift cable (1) fully into the console until it snaps into place. See Figure . Connect the shift cable terminal to the shift lever pin.
  2. Install the console trim plate. See appropriate SHIFT INTERLOCK SYSTEMS article in AUTOMATIC TRANSMISSIONS. Install the left console trim panel.
  3. Insert the shift cable into the bracket. See Figure . Connect the shift cable terminal to the transaxle manual shift lever pin.
  4. Insert the retainer to the shift cable mechanism. See Figure . Adjust the shift cable. See SHIFT CABLE  under ADJUSTMENTS.


  1. Install the shift control cable to the vehicle. See Figure . Install the cable end cap to the floor shift assembly. See Figure . Install the console center trim panel.
  2. Install the left closeout insulator panel. Install the cable into the retaining bracket. See Figure . Push down on the locking tab. Install the cable end cap to the transmission position switch lever.
scientia non olet · About LEMON Manuals