LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Automatic Transmission Servicing) >> Removal & Installation >> Oil Cooler Pipe Hose/Pipe >> Removal (Eldorado)

Removal (Eldorado)

WARNING: This page is about a different car, the 2002 Cadillac Seville, 2002 Cadillac Eldorado, and 2002 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper filler panel. See Fig 1 . Remove the air cleaner assembly. Remove the upper transaxle oil cooler pipe fitting from the radiator. See Fig 2 .
  2. Remove the lower transaxle oil cooler pipe fitting from the radiator. Slide the plastic cap off the lower transaxle oil cooler pipe quick connect fitting.
  3. Disconnect the lower transaxle oil cooler pipe from the transaxle using the Cooler Quick Connect Tool (J-41623-B). See Figure . Remove the lower transaxle oil cooler pipe from the vehicle.
  4. Raise and support the vehicle. Remove the rear exhaust manifold pipe in order to gain access to the upper transaxle oil cooler pipe quick connect fitting.
  5. At the rear of the transaxle slide the plastic cap off the upper transaxle oil cooler pipe quick connect fitting. See Figure . Remove the upper transaxle oil cooler pipe wire retainers from the oil cooler pipe. Remove the upper transaxle oil cooler pipe from the vehicle.
Fig 1: Removing & Installing Upper Filler (Eldorado)
G00094559Courtesy of GENERAL MOTORS CORP.
Fig 2: Identifying Oil Cooler Lines (Eldorado)
G00094560Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals