LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 594 (Engine Mechanical - 3.4L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm Cover Removal - Left

Valve Rocker Arm Cover Removal - Left

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Rocker Arm Cover - Left
    GM54369Courtesy of GENERAL MOTORS CORP.
    NOTE: Valve rocker arm cover gasket and sealant must be carefully trimmed away from lower intake manifold gasket. Failure to do so will damage the lower intake manifold gasket, causing a severe oil leak.
    IMPORTANT: When removing the valve rocker arm cover make sure the gasket stays in place attached to the cylinder head.
  1. Remove the valve rocker arm cover bolts.
  2. Remove the valve rocker arm cover.
    3. Fig 2: Identifying Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
  3. Trim valve cover gasket and sealant away from lower intake manifold gasket at the cylinder head to lower intake manifold joints (1).
  4. Remove the valve rocker arm cover gasket.
scientia non olet · About LEMON Manuals