LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Frame And Underbody) >> Repair Instructions >> Damaged Cage Nut Service >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Approved Equipment for Collision Repair Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (LA1) or Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.
  3. Fig 1: Location Of Measurements
    GM1193723Courtesy of GENERAL MOTORS CORP.
  4. Remove all related panels and components.
  5. CAUTION: Refer to Foam Sound Deadeners Caution in Cautions and Notices.
  6. Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.
  7. Perform the necessary procedures to gain access to repair. Refer to Carpet Replacement in Interior Trim.
  8. Fig 2: Cage Nut Access Panel Mark Cuts
    GM1193728Courtesy of GENERAL MOTORS CORP.
  9. Mark cut the location for access to the cage nut.
  10. Fig 3: Cutting Access Panel
    GM1193735Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do NOT damage any inner panels or reinforcements.
  11. Cut the floor panel.
  12. Fig 4: Removing Cut Panel
    GM1193737Courtesy of GENERAL MOTORS CORP.
  13. Remove the floor panel, accessing the cage nut.
  14. Fig 5: Locating Cage Nut
    GM1193742Courtesy of GENERAL MOTORS CORP.
  15. Using a flat-bladed tool, pry open the cage nut retainer just enough to remove the cage nut.
  16. Fig 6: Removing Damaged Cage Nut
    GM1193745Courtesy of GENERAL MOTORS CORP.
  17. Remove the damaged cage nut from the retainer.