LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Automatic Transmission Servicing) >> Removal & Installation >> Reverse Servo (4T65-E) >> Removal

Reverse Servo (4T65-E): Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct. Remove the right exhaust manifold. Depress the reverse servo cover. See Fig 1 .
  2. Remove the snap ring. See Fig 2 . Pull the O-ring seal out through the slot in the case. Use side cutting pliers in order to cut the servo cover O-ring seal.
  3. Depress the reverse servo cover, grasp one end of the cut seal and pull the seal out of the servo cover.
  4. Remove the reverse servo cover. Remove the servo assembly. Remove the servo spring.
  5. For servo disassembly and inspection, see appropriate OVERHAUL article in AUTOMATIC TRANSMISSIONS.
Fig 1: Removing & Installing Reverse Servo Assembly Cover
G00057600Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Reverse Servo Assembly
G00073385Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals