LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Automatic Transmission Servicing) >> Removal & Installation >> Forward Servo (4T65-E) >> Installation

Forward Servo (4T65-E): Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the servo spring. Install the servo piston assembly. Install the forward servo cover O-ring. Install the forward servo cover. See Figure .
  2. Using a long screwdriver in order to pry against the vehicle frame. Hold the servo assembly compressed. See Figure . Install the 3 forward servo cover attaching bolts. Tighten the forward servo cover attaching bolts to specification. See TORQUE SPECIFICATIONS  .
  3. Remove the drain pan from under the forward servo cover. Align the rear transaxle mount and bracket then Install the mount and bracket bolts. See appropriate REMOVAL & INSTALLATION article.
  4. Remove the transaxle support stand. Install the power steering pressure hose. Install the power steering return hose. See appropriate POWER RACK & PINION article in STEERING.
  5. Install the power steering gear heat shield. See appropriate POWER RACK & PINION article in STEERING. Lower the vehicle. Fill transaxle with appropriate fluid to proper level. See LUBRICATION  .
scientia non olet · About LEMON Manuals