LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Wheel Opening >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screws from the rear wheel opening molding.
    Fig 1: View Of Rear Wheel Opening Molding
    GM755130Courtesy of GENERAL MOTORS CORP.
  2. Pull the upper edge of the rear wheel opening molding out, to release the retainers.
  3. A thin, plastic flat-bladed tool may be used between the molding and the body to help release the wheel opening molding retainers.
  4. Remove the rear wheel opening molding from the vehicle.
scientia non olet · About LEMON Manuals