LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use a heat gun J 25070  .
  2. Position the lower flange of the rear body panel molding to the hem flange of the endgate, pulling upward and forward to align the retainer clips to the holes in the endgate.
    Fig 1: Rear Body Panel Molding Retainers
    GM621021Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not touch the adhesive backing on the molding.
  3. Remove the protective liner from the back side of the rear body panel molding.
  4. Position the upper edge of the rear body panel molding retainer clips to the holes in the endgate.
  5. Install the retainer clips to the endgate by pressing in until fully seated.
  6. Install the upper edge of the rear body panel molding by applying pressure to the entire length of the molding starting at the center and working outward in order to ensure a maximum bond to the endgate.
  7. Install the license lamp. Refer to License Lamp Replacement (Aztek) or License Lamp Replacement (Rendezvous) in Lighting Systems.
  8. Install the license plate.
scientia non olet · About LEMON Manuals