LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Door Body Side (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lower support retainer with the notch down and the retainers to the holes in the door panel.
    Fig 1: View Of Rear Door Body Side Molding Lower Support
    GM622282Courtesy of GENERAL MOTORS CORP.
  2. Install in the center pins of the retainers using a small hammer.
    Fig 2: Installing Center Pins In Retainer
    GM622269Courtesy of GENERAL MOTORS CORP.
  3. Position the lower edge of the molding to the lower door retainer.
    Fig 3: View Of Rear Door Body Side Molding
    GM755480Courtesy of GENERAL MOTORS CORP.
  4. Align the door molding retainers to the holes in the door.
  5. Press the molding to the door until the retainers are fully seated.
  6. Close the rear door.
scientia non olet · About LEMON Manuals