LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Liftgate Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lift gate upper molding to the lift gate.
    Fig 1: Locating Lift Gate Upper Molding Screws
    GM851577Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the lift gate upper molding screws.

    Tighten:  Tighten the screws to 2.0 N.m (18 lb in).

  3. Install the lift gate lower molding. Refer to Molding Replacement - Liftgate Lower .
  4. Install the lift gate applique. Refer to Liftgate Applique Replacement in Body Rear End.
  5. Install the lift gate handle. Refer to Handle Replacement - Endgate in Body Rear End.
scientia non olet · About LEMON Manuals