LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Wheel Opening (Rendezvous) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screws from the front wheel opening molding.
    Fig 1: Locating Front Wheel Opening Molding Screws (Rendezvous)
    GM755150Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws from the front corner of the fascia.
  3. Pull outward on the corner of the front fascia to access the front wheel opening molding retainer.
    Fig 2: Pulling Outward On Front Fascia (Rendezvous)
    GM851583Courtesy of GENERAL MOTORS CORP.
  4. A thin, plastic flat-bladed tool may be used between the fender and molding to help release the retainers.

    Remove the front wheel opening molding from the fender.

    Fig 3: Front Wheel Opening Molding (Rendezvous)
    GM851585Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel opening molding retainers from the molding, if necessary.
    Fig 4: Wheel Opening Molding Retainers (Rendezvous)
    GM851589Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals