LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Door (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:
    • Dimension (a) is 41 mm (1.625 in) from the rear door edge to the emblem/nameplate.
    • Dimension (b) is 146 mm (5.750 in) from the feature line on the door to the bottom of the emblem/nameplate.
    Fig 1: Identifying Location Of Emblem/Nameplate (Aztek)
    GM795565Courtesy of GENERAL MOTORS CORP.
  2. Warm the door surface with a heat gun J 25070  152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
    IMPORTANT: Do not touch the adhesive backing of the emblem/nameplate.
  3. Remove the backing from the front end of the emblem/nameplate.
  4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
  5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
  6. Inspect the emblem/nameplate for bonding.
  7. Remove the tape from the area around the door emblem.
scientia non olet · About LEMON Manuals