LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Exterior Trim) >> Repair Instructions >> Emblem Replacement - Grille >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the emblem to the grille.
    Fig 1: Locating Grille Emblem
    GM795167Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut to the grille emblem.

    Tighten:  Tighten the nut to 2 N.m (18 lb in).

    Fig 2: View Of Back Of Grille Emblem
    GM795188Courtesy of GENERAL MOTORS CORP.
  3. Install the grille to the front fascia. Refer to Fascia Grille Replacement (Aztek) or Fascia Grille Replacement (Rendezvous) in Bumpers.
scientia non olet · About LEMON Manuals