LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 583 (Theft Deterrent System) >> Diagnostic Information and Procedures >> DTC P1626: Theft Deterrent Fuel Enable Signal Lost >> Circuit Description

Circuit Description

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

The theft deterrent control module produces the theft deterrent fuel enable signal when ignition is ON and the proper transponder key value is detected. The powertrain control module (PCM) monitors the fuel enable signal during crank. If the proper signal is present on the Serial Data Circuit, the PCM enables the fuel delivery in order to allow the engine to start. If the PCM determines that the fuel enable signal is not present or incorrect while the engine is running the PCM will enter a fail enable state. The engine will not stall or stop running. If the PCM is fail enable the Pass Key III system is NOT active and the engine will start. Refer to Vehicle Theft Deterrent (VTD) Description and Operation .

scientia non olet · About LEMON Manuals