LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 582 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Front Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper fascia. Refer to Fascia Replacement - Front Bumper - Upper (Aztek)  or Fascia Replacement - Front Bumper - Upper (Rendezvous)  .
  2. Remove the energy absorber. Refer to Energy Absorber Replacement - Front (Aztek)  or Energy Absorber Replacement - Front (Rendezvous)  .
  3. Remove the bolt from the upper inboard impact bar through the access hole in the radiator support.
    Fig 1: Cross Sectional View Of Upper Inboard Impact Bolt
    GM621482Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the horn.
  5. Remove the horns from the impact bar.
    Fig 2: Locating Horns Mounting Bolts
    GM621492Courtesy of GENERAL MOTORS CORP.
  6. Remove the remainder of the impact bar bolts.
    Fig 3: View Of Impact Bar Bolts
    GM621493Courtesy of GENERAL MOTORS CORP.
  7. Remove the impact bar.
scientia non olet · About LEMON Manuals