LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 579 (Seat System) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Seat Cushion Trim Panel Components
    GM629075Courtesy of GENERAL MOTORS CORP.
  1. Install the retainer slot on the rear seat cushion trim panel to tab on the recliner hinge.
  2. Install the rear seat cushion trim panel by sliding down until the retainer slot is fully seated on the recliner hinge tab.
    3. Fig 2: Locating Rear Seat Cushion Trim Panel Screw
    GM629072Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screw to the rear seat cushion trim panel.

    Tighten:  Tighten the rear seat cushion trim panel screw to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals