LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 579 (Seat System) >> Repair Instructions >> Seat Back Cover Replacement - Rear (Bucket) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bucket seat. Refer to Seat Replacement - Rear Bucket .
  2. Remove the rear seat back trim panel. Refer to Trim Panel Replacement - Rear Seat Back .
  3. Remove the rear seat back from the front seat. Refer to Seat Back Replacement - Rear (Split Bench)  or Seat Back Replacement - Rear (Bucket) .
  4. Remove the rear seat headrest. Refer to Head Restraint Replacement - Rear Seat .
    5. Fig 1: Locating J-Hook Retainer
    GM627453Courtesy of GENERAL MOTORS CORP.
  5. Remove the J-hook retainer at the bottom of the seat back cover.
    6. Fig 2: Aligning Front Seat Back Cover End Flaps
    GM627456Courtesy of GENERAL MOTORS CORP.
  6. Pull out the rear seat back cover end flaps.
  7. Remove the hook and the loop retainers securing the rear seat back cover to the pad.
    8. Fig 3: Pulling Seat Back Cover Up & Over Pad
    GM627460Courtesy of GENERAL MOTORS CORP.
  8. Remove the rear seat back cover from the seat back, by pulling the seat back cover up and over the pad.
    9. Fig 4: View Of Hog Rings
    GM627477Courtesy of GENERAL MOTORS CORP.
  9. Remove the hog rings from the rear seat back cover to the pad.
  10. Remove the rear seat back cover from the pad.
scientia non olet · About LEMON Manuals