LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 579 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Rear (Split Bench) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Seat Adjuster
    GM629155Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat adjuster to the rear seat cushion frame.
    2. Fig 2: Installing Rear Seat Adjuster Bolts
    GM627494Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts to the rear seat adjuster.

    Tighten:  Tighten the rear adjuster bolts to 10 N.m (89 lb in).

  3. Install the rear split bench seat release handle and bezel.
  4. Install the rear split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
scientia non olet · About LEMON Manuals