LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 576 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the ends of the weatherstrip to the endgate pinch-weld flange corners.
    Fig 1: View Of Endgate Weatherstrip In Pinch-Weld Flange
    GM621872Courtesy of GENERAL MOTORS CORP.
  2. Install the push-in retainers to the holes in the pinch-weld flange.
  3. Install the endgate weatherstrip to the pinch-weld flange working from each end toward the center.
scientia non olet · About LEMON Manuals