LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 576 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - Liftgate (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the trim panel to the lift gate.
    Fig 1: View Of Access Trim Panel (Rendezvous)
    GM776436Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Discard the old trim panel fasteners. Install new fasteners.
  2. Install new fasteners to the trim panel.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws to the bottom of the trim panel.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  4. Install the access trim panel to the lift gate.
  5. Close the lift gate.
scientia non olet · About LEMON Manuals