LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 576 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the endgate.
  2. Remove the endgate inside handle from the endgate. Refer to Handle Replacement - Endgate .
  3. Remove the endgate trim panel from the endgate inner panel using J 38778  .
    Fig 1: View Of Endgate Trim Panel
    GM620958Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals