Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not touch the adhesive backing.
- Remove the backing tape from the underside of the spoiler.
- Install the rear spoiler to the liftgate, pressing into place until the adhesive is fully seated.
NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the nuts to the rear liftgate spoiler.
Tighten: Tighten the rear liftgate spoiler nuts to 6 N.m (53 lb in).
- Install the rear liftgate spoiler water channel.
- Install the liftgate trim. Refer to Trim Panel Replacement - Liftgate (Aztek) or Trim Panel Replacement - Liftgate (Rendezvous) .