LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 576 (Body Rear End) >> Repair Instructions >> Hinge Replacement - Liftgate (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the liftgate hinges with the shims and seals to the location marks on vehicle.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts to the liftgate hinges.

    Tighten:  Tighten the liftgate hinge nuts to 33 N.m (28 lb ft).

    Fig 1: Locating Liftgate Hinge Bolts (Rendezvous)
    GM754963Courtesy of GENERAL MOTORS CORP.
  3. Install the liftgate. Refer to Liftgate Replacement (Rendezvous) .
scientia non olet · About LEMON Manuals