LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 576 (Body Rear End) >> Repair Instructions >> Handle Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the endgate handle to the endgate handle assembly.
    Fig 1: Identifying Endgate Handle Assembly
    GM625149Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts to the endgate handle.

    Tighten:  Tighten the endgate handle bolts to 10 N.m (89 lb in).

  3. Close the endgate.
scientia non olet · About LEMON Manuals