LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 574 (Garage Door Opener System) >> Repair Instructions >> Garage Door Opener Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the barbed tab at the center of the access panel.
    Fig 1: Pressing Access Panel Barbed Tab
    GM323059Courtesy of GENERAL MOTORS CORP.
  2. Swing the panel down and forward in order to access the module.
    Fig 2: Aligning Access Panel
    GM323063Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector from the module and switch assembly.
  4. Remove the screws that retain the garage door opener and the to the console.
    Fig 3: Identifying Garage Door Opener & Switch Assembly Retaining Screws
    GM323068Courtesy of GENERAL MOTORS CORP.
  5. Remove the opener and the switch assembly from the console.
scientia non olet · About LEMON Manuals