LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 574 (Garage Door Opener System) >> Repair Instructions >> Garage Door Opener Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the LED indicator with the hole in the access panel when setting the opener into place.
    Fig 1: Identifying Garage Door Opener & Switch Assembly Retaining Screws
    GM323068Courtesy of GENERAL MOTORS CORP.
  2. Install the opener and the switch assembly to the console.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws that retain the opener and the switch assembly to the console.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  4. Connect the electrical connector to the opener and the switch assembly.
  5. Swing the access panel up and rearward in order to close the access panel.
    Fig 2: Aligning Access Panel
    GM323063Courtesy of GENERAL MOTORS CORP.
  6. Snap the barbed tab into place in the console.
    Fig 3: Pressing Access Panel Barbed Tab
    GM323059Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals