Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Seat Belt Retractor

Courtesy of GENERAL MOTORS CORP.

Install the seat belt retractor to the center pillar.

Fig 2: View Of Seat Belt Retractor Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolt to the seat belt retractor.
Tighten: Tighten the bolt to 42 N.m (31 lb ft).
Install the center pillar lower trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.

Fig 3: Locating Seat Belt Guide Loop

Courtesy of GENERAL MOTORS CORP.

Place the seat belt guide loop to the guide adjuster bracket.

Fig 4: View Of Seat Belt Guide Loop Nut

Courtesy of GENERAL MOTORS CORP.

Install the nut to the seat belt guide loop.
Tighten: Tighten the nut to 42 N.m (31 lb ft).
Install the seat belt guide loop cover.

Fig 5: View Of Front Seat Belt Anchor

Courtesy of GENERAL MOTORS CORP.

Place the seat belt anchor plate to the seat rear outboard stud.
Install the front bucket seat. Refer to Seat Replacement - Bucket in Seats.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 .