LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 572 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Prior to VIN 4S558922 (100mm Sender)) Fuel Tank Replacement (VIN 4S558922 and Later (130mm Sender)) .
    2. Fig 1: Identifying Evaporative Emission (EVAP) Canister Vent Solenoid Harness Connector
    GM238422Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the evaporative emission (EVAP) canister vent solenoid harness connector.
  3. Remove the EVAP vent hose from EVAP canister solenoid.
    4. Fig 2: Identifying EVAP Canister & Purge Pipe
    GM670190Courtesy of GENERAL MOTORS CORP.
  4. Bend the EVAP canister vent bracket tab to release the EVAP canister vent solenoid.
  5. Remove the EVAP canister solenoid (2) from the fuel tank.
scientia non olet · About LEMON Manuals