LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Steering Wheel & Steering Column) >> Repair Instructions >> Seal Replacement - Intermediate Steering Shaft >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Collapse the lower intermediate shaft seal into the upper intermediate shaft seal.
  2. Install the intermediate shaft seal over the intermediate shaft from inside the vehicle.
  3. Connect the intermediate shaft to the steering column. Refer to Intermediate Steering Shaft Replacement .
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the upper intermediate shaft pinch bolt.

    Tighten:  Tighten the intermediate shaft seal bolts to 48 N.m (35 lb ft).

    5. Fig 1: Locating Intermediate Shaft Seal Bolts
    GM633876Courtesy of GENERAL MOTORS CORP.
  5. Install the intermediate shaft seal bolts.

    Tighten:  Tighten the intermediate shaft seal bolts to 3 N.m (27 lb in).

  6. Connect the intermediate shaft seal to the steering column.
    7. Fig 2: View Of Intermediate Steering Shaft To Power Steering Gear Stub Shaft
    GM294371Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Rotate the lower seal in order to obtain proper shaft to seal clearance.
  7. Install the left closeout panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  9. Connect the lower intermediate shaft seal to the steering gear.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals