LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Ignition Coil(s) Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil(s).
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the ignition coil bolt(s).

    Tighten:  Tighten the ignition coil bolt(s) to 10 N.m (89 lb in).

  4. Fig 2: View Of Ignition Coil Electrical Connector
    GM1394057Courtesy of GENERAL MOTORS CORP.
  5. Connect the ignition coil electrical connector(s).