LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Hose, Fuel Feed - Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
  2. Remove the air inlet duct. Refer to Air Cleaner Intake Duct Replacement .
  3. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
  4. Remove the fuel pressure and evaporative emission (EVAP) hoses from the engine. Refer to Quick Connect Fitting(s) Service (Metal Collar)  and Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 1: Identifying Purge Line & Purge Line Retainer
    GM1401471Courtesy of GENERAL MOTORS CORP.
  5. Remove the purge line from the purge line retainer.
  6. Remove the throttle body. Refer to Throttle Body Assembly Replacement .
    7. Fig 2: View Of Fuel Feed Hose Bracket Bolt
    GM1401470Courtesy of GENERAL MOTORS CORP.
  7. Remove the fuel feed hose bracket bolt.
    8. Fig 3: Locating Fuel Feed Hose From The Fuel Rail
    GM1401465Courtesy of GENERAL MOTORS CORP.
  8. Use the Snap-On® ACT1370 Disconnect Set or equivalent to disconnect the fuel feed hose from the fuel rail.
  9. Carefully remove the purge line retainer from the fuel feed hose bracket as necessary.
scientia non olet · About LEMON Manuals