LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 2 (Left) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. Fig 1: View Of Camshaft Position (CMP) Actuator Valve Electrical Connector
    GM1394071Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the camshaft position (CMP) actuator valve electrical connector (1).
    3. Fig 2: Identifying CMP Actuator Valve & Bolt
    GM1395978Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP actuator valve bolt.
  4. Remove the CMP actuator valve.
scientia non olet · About LEMON Manuals