LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 564 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Trim Plate Bezel
    GM771732Courtesy of GENERAL MOTORS CORP.
  1. Install the trim plate bezel. Press the bezel into place until seated.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the steering column bracket nuts.

    Tighten:  Tighten the nuts to 24 N.m (18 lb ft).

  3. Install the DIC switch to the trim plate bezel. Refer to Driver Information Center Switch Replacement (Rendezvous)  or Driver Information Center Switch Replacement (Aztek) .
  4. Install the knee bolster panel. Refer to Knee Bolster Replacement .
scientia non olet · About LEMON Manuals