Scan Tool Output Controls
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Coolant Gage Sweep Test | Special Functions: IPC Gages | The IPC commands this gage to sweep to its maximum when you select UP. Then the gage is commanded to sweep to its minimum when you select DOWN. |
| Fuel Gage Sweep Test | Special Functions: IPC Gages | The IPC commands this gage to sweep to its maximum when you select UP. Then the gage is commanded to sweep to its minimum when you select DOWN. |
| Lamp Test | Special Functions: Lamp Test | The IPC illuminates the following indicators when you select On:
The indicators should illuminate until commanded Off. The IPC Tech 2 display will also change the states of Ignition 0, the DIC Reset switch, the DIC Mode switch, and the Trip Odometer Reset switch. |
| Speed Gage Sweep Test | Special Functions: IPC Gages | The IPC commands this gage to sweep to its maximum when you select UP. Then the gage is commanded to sweep to its minimum when you select DOWN. |
| Tach Gage Sweep Test | Special Functions: IPC Gages | The IPC commands this gage to sweep to its maximum when you select UP. Then the gage is commanded to sweep to its minimum when you select DOWN. |