LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 564 (Instrument Panel System Displays, Gauges And Console) >> Diagnostic Information and Procedures >> Change Engine Oil Indicator Inoperative

Change Engine Oil Indicator Inoperative

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Change Engine Oil Indicator Inoperative

Step Action Yes No
Schematic Reference:  Instrument Cluster Schematics  
1 Did you perform the Diagnostic System Check - Instrument Cluster? Go to Step 2  Go to Diagnostic System Check - Instrument Cluster 
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the Engine Oil Life Remaining parameter in the PCM Data 2 data list.
Does the scan tool display zero percent with the Change Engine Oil message inoperative?		 Go to Step 3  System OK
3
IMPORTANT: Perform the compass calibration and variance procedure on the replacement instrument panel cluster (IPC).
Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement .Did you complete the replacement?		 Go to Step 4  -
4 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals