LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter Upper (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear roof garnish molding. Refer to Garnish Molding Replacement - Rear Upper  .
  2. Remove the rear seat belt guide loop from the rear upper quarter trim panel. Refer to Seat Belt Retractor Replacement - Rear in Seat Belts.
    3. Fig 1: Locating Rear Upper Quarter Trim Panel
    GM1130486Courtesy of GENERAL MOTORS CORP.
  3. Remove the screw from the rear upper quarter trim panel.
    4. Fig 2: Identifying Upper Quarter Trim Push Pin
    GM1130536Courtesy of GENERAL MOTORS CORP.
  4. Remove the push pins from the upper quarter trim.
    5. Fig 3: Rear Quarter Upper Trim Panel
    GM1130457Courtesy of GENERAL MOTORS CORP.
  5. Remove the trim panel from the inner panel, by pulling the panel to release the push-in retainers.
  6. Remove the trim panel from the vehicle.
scientia non olet · About LEMON Manuals