LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission Servicing) >> Removal & Installation >> Shift Cable (Floor Shift) >> Installation

Shift Cable (Floor Shift): Installation

WARNING: This page is about a different car, the 2002 GMC Sonoma, 2002 GMC Jimmy, 2002 Chevrolet S10 Pickup, and 2002 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the transmission is in the mechanical Neutral position. Adjust the shift cable. See SHIFT CABLE  under ADJUSTMENTS. Following the shift cable adjustment procedure, install the shift cable end of the shift cable to the gearshift lever stud ball.
  2. Install the retainer to the shift cable and transmission bracket. Feed the shift cable through the floor panel. See Fig 2. Lower the vehicle.
  3. Install the tape and grommet on the shift cable to the floor panel. Install the retainer securing the shift cable to the shift controller. See Fig 1.
  4. Install the console. See REMOVAL & INSTALLATION in appropriate SHIFT INTERLOCK SYSTEMS article in AUTOMATIC TRANSMISSIONS. Install the front mat and carpet.
Fig 1: Removing & Installing Cable At Floor Shift Assembly
G00089896Courtesy of GENERAL MOTORS CORP.
Fig 2: Shift Cable Routing Under Carpet
G00089897Courtesy of GENERAL MOTORS CORP.
Fig 3: Identifying Shift Cable Location & Routing
G00088347Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals