Filler Tube: Installation
WARNING: This page is about a different car, the 2002 GMC Sonoma, 2002 GMC Jimmy, 2002 Chevrolet S10 Pickup, and 2002 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new seal into the transmission case. Install the filler tube into the seal. Install the bolt securing the filler tube to the transmission torque converter housing. See Fig 3. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- Raise the transmission. Install the transmission cross member and remove the jack. See Fig 2.
- On 4.3L models, install the rear propeller shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVE AXLES. Install the exhaust manifold pipe. On all models, lower the vehicle. On 2.2L models, install the bolt securing the dipstick to the exhaust manifold. See Fig 1. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- On all models, install the transmission oil level indicator. Fill transmission with appropriate fluid to proper level. See LUBRICATION .