LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Automatic Transmission Servicing) >> Removal & Installation >> Extension Housing Rear Oil Seal >> Installation

Extension Housing Rear Oil Seal: Installation

WARNING: This page is about a different car, the 2002 GMC Sonoma, 2002 GMC Jimmy, 2002 Chevrolet S10 Pickup, and 2002 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the inside diameter of the new seal with assembly lubricant. Use the seal installer with a soft faced mallet to install the seal.
  2. Install the seal to the extension housing. See Fig 2. Install the propeller shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVE AXLES.
  3. Remove the drain pan and lower the vehicle. Fill transmission with appropriate fluid to proper level. See LUBRICATION .
Fig 1: Removing Rear Extension Housing Seal
G00088371Courtesy of GENERAL MOTORS CORP.
Fig 2: Installing Rear Extension Housing Rear Oil Seal
G00088372Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals