Power Window Inoperative - Passenger Door
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Power Window Inoperative - Passenger Door
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Power Window Schematics Connector End View Reference: Power Door Systems Connector End Views |
|||
| 1 | Did you perform the Door Systems Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Door Systems |
| 2 | Verify that the inoperative passenger door power window fault is present. Do the passenger door power windows operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Is the inoperative window the front passenger window? | Go to Step 5 | Go to Step 4 |
| 4 | Are the driver, LR and RR windows all inoperative? | Go to Step 9 | Go to Step 6 |
| 5 |
|
Go to Step 7 | Go to Step 16 |
| 6 |
|
Go to Step 7 | Go to Step 10 |
| 7 |
|
Go to Step 8 | Go to Step 11 |
| 8 |
|
Go to Step 14 | Go to Step 12 |
| 9 | Test the accessory voltage circuit for an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 20 | Go to Step 13 |
| 10 | Test the power window master switch lockout signal circuit of the appropriate window switch for an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 20 | Go to Step 13 |
| 11 | Test the appropriate power window master switch signal circuits of the appropriate window switch for a short to voltage or an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 20 | Go to Step 13 |
| 12 | Test the appropriate power window motor up and down circuits of the appropriate window motor for a short to voltage or an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 20 | Go to Step 15 |
| 13 | Inspect for poor connections at the harness connector of the driver window switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 20 | Go to Step 17 |
| 14 | Inspect for poor connections at the harness connector of the appropriate window motor. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 20 | Go to Step 18 |
| 15 | Inspect for poor connections at the harness connector of the appropriate window switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 20 | Go to Step 19 |
| 16 | Repair the open in the accessory voltage circuit. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 20 | - |
| 17 | Replace the driver window switch. Refer to Power Window Switch Replacement - Left Front (Aztek) or Power Window Switch Replacement - Left Front (Rendezvous) . Did you complete the replacement? |
Go to Step 20 | - |
| 18 | Replace the appropriate window motor. Refer to Window Regulator Replacement - Front Door or Window Regulator Replacement - Rear Door . Did you complete the replacement? |
Go to Step 20 | - |
| 19 | Replace the appropriate window switch. Refer to Power Window Switch Replacement - Right Front (Aztek) or Power Window Switch Replacement - Right Front (Rendezvous) or Power Window Switch Replacement - Rear Door (Aztek) or Power Window Switch Replacement - Rear Door (Rendezvous) . Did you complete the replacement? |
Go to Step 20 | - |
| 20 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |