LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 551 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Rear (Utility) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear seat belt buckle assembly to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the rear seat belt buckle assembly retaining nuts.

    Tighten 

    Tighten the rear seat belt buckle assembly retaining nuts to 42 N.m (31 lb ft).

    Fig 1: Installing Rear Seat Belt Buckle Assembly (Utility)
    G01478439Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals