LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 551 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the passenger-side seat belt buckle or buckle and belt assembly to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolt that retains the passenger-side seat belt buckle or buckle and belt assembly to the vehicle.

    Tighten 

    Tighten the seat belt buckle or buckle and belt assembly bolt to 70 N.m (52 lb ft).

    Fig 1: Installing Passenger-Side Seat Belt Buckle & Bolt
    G01478433Courtesy of GENERAL MOTORS CORP.
  3. Install the driver-side seat belt buckle or buckles to the seat.
  4. Install the bolt that retains the driver-side seat belt buckle or buckles to the seat.

    Tighten 

    Tighten the seat belt buckle or buckles bolt to 70 N.m (52 lb ft).

    Fig 2: Installing Driver-Side Seat Belt Buckle & Bolts
    G01478434Courtesy of GENERAL MOTORS CORP.
  5. Connect the driver-side seat belt buckle electrical connector.
    Fig 3: Connecting Driver-Side Seat Belt Buckle Electrical Connector
    G01478435Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals