LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 550 (Body Rear End) >> Repair Instructions >> Handle Replacement - Rear Door Inside >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the endgate.
  2. Remove the screws that retain the inside handle to the endgate handle assembly.
  3. Drill out the rivets that retain the endgate handle assembly to the endgate.
  4. Remove the endgate handle assembly from the endgate.
    Fig 1: Removing Endgate Handle Assembly From Endgate
    G01478251Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals