LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Automatic Transmission Servicing) >> Removal & Installation >> Oil Cooler Lines >> Removal

Oil Cooler Lines: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Remove the oil cooler lines from the radiator and transmission. See Figure .
    2. NOTE: Perform the following procedures when removing the retaining ring and cooler line from the quick connect fitting on the radiator and transmission.
  2. Pull the plastic cap back from the quick connect fitting and down along the cooler line about 2". Using a bent-tip screwdriver, pull on one of the open ends of the retaining ring to rotate the retaining ring around the quick connect fitting until the retaining ring is out of position and can be completely removed. See Figure .
  3. Remove the retaining ring from the quick connect fitting. Discard the retaining ring. Pull the cooler line straight out from the quick connect fitting. See Figure .
  4. Remove the retaining ring (E-clip) securing the cooler line to the quick connect to remove the remaining cooler lines from the remaining quick connect fittings. Remove the cooler lines from the vehicle.
scientia non olet · About LEMON Manuals